Top Cisco 352-001 Courses Online - Updated [Feb-2022]
352-001 Practice Dumps - Verified By Dumpexams Updated 270 Questions
NEW QUESTION 75
Refer to the exhibit. The operations team has identified that some of the multi-tiered e-commerce applications have slow performance, due to illegitimate inbound traffic from the Internet. On which network device do you place traffic filtering to improve performance?
- A. D
- B. A
- C. C
- D. B
Answer: D
NEW QUESTION 76
You are the lead IP/MPLS network designer of a service provider called XYZ. You are leading a design discussion regarding IPv6 implementation in the XYZ MPLS network, using MPLS 6PE/6VPE techniques. Currently, XYZ provides IPv4 multicast services over an MPLS network by using MVPN, and would like to provide parallel IPv6 multicast services. Which three multicast solutions should be enabled? (Choose three.)
- A. native IPv6, only for multicast services
- B. an overlay model using Layer 2 MPLS tunnels
- C. MVPN for IPv6 multicast service
- D. MPLS 6PE/6VPE, because it provides IPv6 multicast support by default
- E. PIM-DM to enable IPv6 multicast in conjunction with MPLS 6PE/6VPE
Answer: A,B,C
NEW QUESTION 77
Refer to the exhibit
Refer to the exhibit Assume that no multicast optimization is done on LAN switches A and B Which two solutions can be used to optimize multicast traffic forwarding in this situation? (Choose two )
- A. Enable PIM snooping on both switches
- B. Configure a static MAC entry for the multicast server
- C. Disable the IGMP query election process
- D. Enable IGMP snooping querier on both switches
- E. Disable IGMP snooping on both switches
Answer: D,E
NEW QUESTION 78
Which two design solutions provide IPv6 interdomain multicast? (Choose two)
- A. PIM-DM
- B. Embedded RP
- C. MSDP
- D. Auto-RP
- E. PIM SSM
Answer: B,E
NEW QUESTION 79
Enterprises A and B agree to merge, but keep IGP and BGP independent of each other.
They are served by a common ISP for their Internet connectivity. During the merge, A and
B will provision a point-to-point link between the two networks. What is the simplest design option that will allow data to travel between A and B without passing through the ISP?
- A. configure OSPF and make OSPF routes less attractive than the same routes learned via
EBGP from the ISP - B. configure OSPF between the two networks and block each others route's from the ISP
- C. configure iBGP between the two networks and block each others route's from the ISP
- D. configure EBGP between the two networks and block each other's routes from the ISP
- E. configure OSPF and make OSPF routes more attractive than the same routes learned via EBGP from the ISP
Answer: D
NEW QUESTION 80
When a multiprotocol routing environment is designed to have several routers redistributing among the routing domains, how can routing loops be avoided?
- A. By implementing spanning tree
- B. By using the AS-path attribute
- C. By using route tags
- D. By activating split horizon
Answer: C
NEW QUESTION 81
Which two IEEE standards are commonly used at the data link layer for an access network, in an IoT environment? (Choose two.)
- A. 802.15.4
- B. 802.11
- C. 1901 2 NB-PLC
- D. 802.22
- E. 802.16
Answer: A,B
Explanation:
Section: Evolving Technologies
Explanation/Reference:
NEW QUESTION 82
Refer to the exhibit.
How would you redesign the network to improve availability of the routers 1A and 1B at the core site?
- A. Enable Graceful Restart Helper for OSPF
- B. Use APS Ethernet circuits and redundant interfaces
- C. Create a multichassis system with the two routers
- D. Use link bundles over multiple slots
Answer: C
NEW QUESTION 83
You are designing a Group Encrypted Transport virtual private network solution for an existing branch network. The existing network has the following characteristics:
- 50 remote sites (with an additional 30 remote sites expected over the next 3 years)
- Connectivity between all sites is via Multiprotocol Label Switching Layer 3 virtual private network service from a single provider
- Open Shortest Path First is the routing protocol used between provider edge and customer edge routers
- The customer edge routers will become group members performing the encryption between sites Which additional routing protocol would you use for the overlay routing between the group members?
- A. Open Shortest Path First (with a different process ID)
- B. Routing Information Protocol Version 2
- C. External Border Gateway Protocol
- D. Next Hop Resolution Protocol
- E. Enhanced Interior Gateway Routing Protocol
- F. No additional protocol is necessary.
Answer: F
Explanation:
Explanation/Reference:
Explanation:
29
NEW QUESTION 84
A certain service provider is supporting a customer who uses IPsec tunnels between dual-homed CE routers. The service provider carries infrastructure routes using OSPF and carries tunnel endpoints using BGP. Which two steps will be taken by the service provider to provide fast convergence in case of node failure in its network? (Choose two.)
- A. carry IPsec tunnels in L2TPv3 among PE routers
- B. tune OSPF on all routers
- C. carry IPsec tunnels in VPLS among PE routers
- D. tune BGP on all routers
Answer: B,D
Explanation:
Section: (none)
Explanation/Reference:
NEW QUESTION 85
Drag and drop on the left with the corresponding RIB or FIB function on the right
Answer:
Explanation:
NEW QUESTION 86
Refer to the exhibit.
This diagram depicts the design of a small network that will run EIGRP on R1 and R2, and EIGRP Stub on R3. In which two ways will this network be impacted if there is link instability between R1 and R2? (Choose two.)
- A. R2 will have routes in its routing table that originate from R1 and R3.
- B. R3 will have routes in its routing table that originate from R1 and R2.
- C. R3 will be transit for traffic between R1 and R2.
- D. R3 will not be transit for traffic between R1 and R2.
- E. R1 will have routes in its routing table that originate from R2 and R3.
Answer: B,D
NEW QUESTION 87
Which two functions are performed at the core layer of the three-layer hierarchical network design model? (Choose two).
- A. Reliability
- B. Fast transport
- C. Load balancing
- D. Qos classification and marking boundary
- E. Fault isolation
Answer: A,B
NEW QUESTION 88
What are two potential effects of increasing the percentage of priority traffic? (Choose two.)
- A. must be avoided regardless of traffic patterns
- B. makes it impossible to bound the impact that priority traffic will have on non-priority traffic
- C. can increase latency and jitter for priority traffic
- D. can increase latency and jitter for non-priority traffic
- E. will not ever change the performance of non-priority traffic
Answer: C,D
NEW QUESTION 89
Refer to the exhibit.
Which impact of using three or more ABRs between the backbone area and area 1 is true?
- A. Prefixes from the non-backbone area are advertised by one ABR to the backbone area.
- B. In a large-scale network multiple ABRs can create microloops
- C. Multiple ABRs reduce the CPU processing on each ABR due to splitting prefix advertisement between areas
- D. In a large-scale network LSA replication by all ABRs can cause serious scalability issues
Answer: A
NEW QUESTION 90
You are designing a NAC OOB Layer 3 Real-IP Gateway deployment for a customer. Which VLAN must be trunked back to the Clean Access Server from the access switch?
- A. untrusted VLAN
- B. authentication VLAN
- C. management VLAN
- D. user VLAN
Answer: A
NEW QUESTION 91 
Refer to the exhibit Assume that no multicast optimization is done on LAN switches A and B Which two solutions can be used to optimize multicast traffic forwarding in this situation? (Choose two )
- A. Enable PIM snooping on both switches
- B. Configure a static MAC entry for the multicast server
- C. Disable the IGMP query election process
- D. Enable IGMP snooping querier on both switches
- E. Disable IGMP snooping on both switches
Answer: D,E
NEW QUESTION 92
Which statement correctly describes how MTU mismatches are addressed in the IS-IS neighbor-formation process?
- A. IS-IS checks the locally configured MTU against the MTU advertised in neighbor hello packets.
- B. IS-IS pads hellos, so neighbor relationships will not be formed on links with mismatched MTUs.
- C. IS-IS does not check for MTU mismatches when forming a neighbor relationship.
- D. IS-IS checks the locally configured MTU against the MTU advertised in neighbor LSPs.
Answer: B
NEW QUESTION 93
Refer to the exhibit. A service provider would like to use Ethernet OAM to detect end-to-end connectivity failures between SP-SW1 and SP-SW2. In which two of these ways can you design this solution? (Choose two.)
- A. Enable Y.1731 Connectivity Fault Management on the SP switches.
- B. Cisco Discovery Protocol PDUs must be forwarded over the VPLS.
- C. E-LMI PDUs must be forwarded over VPLS.
- D. Enable IEEE 802.1ag Connectivity Fault Management on the SP switches.
- E. Use upward maintenance endpoints on the SP switches.
Answer: D,E
NEW QUESTION 94
You are the Cisco Network Designer in P4S. Which two
statements about Layer 3 access designs are correct? (Choose two.)
- A. Fast uplink convergence is supported for failover and fallback.
- B. Convergence time is fractionally slower than STP.
- C. Broadcast and fault domains are increased.
- D. IP address space is difficult to manage.
Answer: A,D
Explanation:
Section: (none)
Explanation/Reference:
NEW QUESTION 95 
Refer to the exhibit. In this network design where should summarization occur to provide the best summarization and optimal paths during a single-failure incident as well as during normal operation?
- A. a single identical summary for all the branch offices placed on routers 1A, 1B, 2A and 2B
- B. two summaries on 1A and 1B, and two summaries on 2A and 2B.
- C. a single identical summary on 3A and 3B
- D. a single summary on each aggregation device for the branches connected to them.
Answer: C
NEW QUESTION 96
For a storage area network design, which technology allows a switch to support multiple
Fibre Channel IDs per fabric port?
- A. Inter-Virtual Storage Area Network Routing
- B. Zoning
- C. Expansion Port Trunking
- D. Fabric Port Trunking
- E. Node Port Virtualization
- F. N-Port Identifier Virtualization
Answer: F
NEW QUESTION 97
......
What is the duration of the 352-001 Exam
- Length of Examination: 120 minutes
- Format: Multiple choices, multiple answers
- Number of Questions: 90-110
- Passing Score: 70%
New (2022) Cisco 352-001 Exam Dumps: https://pdftorrent.dumpexams.com/352-001-vce-torrent.html